NANONUT; Figure-Photos, DIY

Tutorial: Neko-Shipo


Ingredients to a Moe-full Tail and Ears.

1 ) Cut the Wire into the Desired Length.

2 ) Cut the Yarn into a length where you think you can wind around the tail to make it fatter.

3 ) Locate 1 side of the yarn, tie a Knot on the wire with the yarn.

4 ) Cut off the excess yarn behind of the knot… There will be 2 ends, one with a ton of yarn, and one with just a little cut the one with a little.

5 ) Use the ton of yarn and spin it on the wire to form a fat tail.

6 ) After spinning to a point where there will not be any yarn left, leave some excess and tie another knot using the yarn around of the wire.

7 ) Tear a fluff of cotton wool and place it at the tip of the tail.

8 ) Use the needle and thread to impale the cotton wool into the tail.

Some Emphasis on the cotton wool.

Some Emphasis on the cotton wool.

9 ) Glue the side without of the cotton wool to prevent it from warping and unraveling into yarn again.

10 ) Wait for it to dry.

Finished!

Yoku Dekimashita!

Yoku Dekimashita!

—-Gallery—-

Left: Prototype, Right: Model 01

Left: Prototype, Right: Model 01

Haruhi with Prototype Nekomimi and Model 01 Shipo

Haruhi with Prototype Nekomimi and Model 01 Shipo

Thanks Kodomut for tips on photography!!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s